Chain link fence privacy slats – A backyard fence helps keep dogs and children, while holding everything else out. Chain link fencing is a popular type of fence of steel woven into a mesh configuration of interlocking squares and attached to steel posts. Although sturdy and durable, offer chain link fence with little regard for privacy. Add privacy slats to your chain link fence provide you the privacy you want without hassle or expense to put up a wooden privacy fence.
Installation of chain link fence privacy slats, unroll chain link mesh on the ground and a voltage slide bar through the chain link at the end of the wire mesh. Power consumption in standby mesh up and bolt tension bar to tension bands at one of the corner positions. Adjust the wire mesh 2 inches above the ground, overlapping the top of the rail 1 to 2 inches. Set the pull bar of the fence puller through the loose mesh a few feet away from the last post and attach the pull bar yoke. Bottom fence puller to pull the chain link mesh taut until no more than 1/4-inch meshes moves when squeezed together.
12 Photos Gallery of: Installation Of Chain Link Fence Privacy Slats
After that to chain link fence privacy slats, hold the fence puller and insert a tension bar into the mask. Secure it to the tensions bands on the corner post near the fence puller. Remove any excess mask by opening a bow on top and bottom and twist the beach beyond. Use your hand to pull the line tension in tension bands on the corner post. Use a socket wrench to tighten the bolts on the tapes. Releasing the fence puller and pull bar. Repeat this process hanging along any remaining sides of the fence. Bend the end of a draw wire into a hook. Grab a scratch beach opening just above the rail and loop wire around the top rail. Pull firmly and tie it up in the mesh. Place a draw wire every 12 to 16 inches along the rail. Assigning line positions tie wires. Put a voltage wire through the bottom loops of wire mesh. Tight wire around the end post and wrap it around several times to attach.